精品推荐
阅读排行
· 工程竣工验收报告· 大学生毕业自我鉴定
· 大学生自我鉴定7
· 大学毕业生自我鉴定
· 大学生学年自我鉴定
· 大学毕业生自我鉴定
· 师范生实习鉴定评语
· 给老师的一封感谢信
· 心理健康教育论文
· 黑板报设计图欣赏
| 作者：不明 来源：www.pccode.net 整理 发布时间：2007-1-24 15:24:51 发布人：wongrs | |||
|
Below are questions 1-19. To see an explanation for each question, please refer to the explanation link below the question or select explanations on the navigation bar to the left. Questions 1. [OxNx] During a TFTP transfer using Cisco Routers what is the numeric value, in decimal, of the destination port field of the User Datagram Protocol (UDP) header? a) 96 b) 47 c) a random number above 1024 d) 69 e) none of the above 2. [CxNx] What is the standard encapsulation method used by Cisco routers for the Internet Protocol (IP) on it’s Ethernet interfaces? a) SNAP b) ARPA c) NOVELL-ETHER d) DARPA e) Ethernet_802.3 3. [CxNx] What will be the correct command on a Cisco router to set the IP address of an interface assuming you are at the "router(config-if)#" prompt? a) ip address 1.1.1.1 255.255.255.0 b) ip address 1.1.1.1 c) ip 1.1.1.1 d) ip 1.1.1.1 255.255.255.0 e) none of the above 4. [CxNx] Which commands will display the IP addresses of all interfaces on a Cisco Router? (Choose all that apply) a) show ip route b) show ip address c) show ip interface d) show interface e) display ip addresses 5. [CxNx] Which of the following commands will display the contents of the ARP cache of your Cisco router? a) show ip arp cache b) show ip route c) show ip arp d) show arp e) there is no way to display the ARP cache 6. [CxNx] Reverse Address Resolution Protocol (RARP) is the process: a) Where an IP host resolves it’s IP address by broadcasting it’s MAC address to the network and a BOOTP server assigns it an IP address. b) Where an IP host resolves it’s MAC address by broadcasting to the local network it’s IP address. c) Where an IP host tries to resolve the MAC address of a destination by sending a network broadcast. The destination responds to the broadcast with it’s MAC address. d) Where an IP host resolves a destination IP address by sending a broadcast on the local network and the destination host responds with it’s IP address. e)There is no such process. 7. [OxNx] Which of the following applications requires the connection-oriented layer four protocol, TCP? (Choose all that apply) a) Telnet b) FTP c) TFTP d) SNMP e) none of the above 8. [RxNx] Which of the following are link state Routing Protocols. (Choose all that apply.) a) IP b) O
|