7.What is the term associated with synchronizing the routing tables after a topology change occurs?

A. flooding
B. broadcasting
C. convergence
D. summarization

    8.Which of the following must be determined first by the router in order to route the data?

A. the distance metric of the data
B. the source address of the data
C. which routing protocol is used by the data
D. whether the protocol suite of the data is active

    9.You are a technician at ABC. ABC has the subnet/mask of 172.29.100.0/26 set aside for small remote locations. Each location will have 5 IP devices connected to the network. Which VLSM mask will provide the minimum number of hosts you require?

A. /27
B. /28
C. /29
D. /30
E. /31

    10.You are a trainee technician at ABC. Your instructor shows you the following route summarization entry:
192.168.134.0/22 Your instructor wants to know how many class C addresses are contained in this summarization. What would your reply be?

A. 1
B. 2
C. 4
D. 8
E. 16

    - BCMSN

    11.Which command enables an EtherChannel bundle on a Catalyst 2900XL switch?

A. Port group
B. Set port channel on
C. Port etherchannel enable
D. Set etherchannel port enable

    12.Which two statements about dynamic VLANs are true? (Choose two)

A. Each switch port is assigned to a specific VLAN.
B. Dynamic VLANs require a VLAN Membership Policy Server.
C. Devices are in the same VLAN regardless of which port they attach to.
D. Dynamic VLAN assignment are made through the command interface.

    13.Which statement is correct about 802.1Q trunking? (Select all that apply)

A. Both switches must be in the same VTP domain.
B. The encapsulation type of both ends of the trunk does not have to match.
C. The native VLAN on both ends of the trunk must be VLAN 1.
D. 802.1Q trunking can only be configured on a Layer 2 port.
E. In 802.1Q trunking, all VLAN packets are tagged on the trunk link, except the native VLAN.

    14.You need to take advantage of FastEthernet ports. Which two actions avoid configuration problems that cause the port to be automatically disabled? (Choose two)

A. Allow some ports in a channel to be disabled.
B. Configure the ports in a channel as dynamic VLAN ports.
C. Configure all ports in a channel to operate at the same speed and duplex mode.
D. Assign all ports in a channel to the same VLAN or configure them as trunk ports.

上一页  [1] [2] [3] [4] [5]  下一页