精品推荐
阅读排行
· 工程竣工验收报告· 大学生毕业自我鉴定
· 大学生自我鉴定7
· 大学毕业生自我鉴定
· 大学生学年自我鉴定
· 大学毕业生自我鉴定
· 师范生实习鉴定评语
· 给老师的一封感谢信
· 心理健康教育论文
· 黑板报设计图欣赏
| 作者：不明 来源：www.pccode.net 整理 发布时间：2007-1-24 15:24:18 发布人：wongrs | |
|
ncapsulation type would you use. (IETF) 19. Which statement is true regarding full duplex.( Allows for transmission and receiving of data simultaneously) 20. Purpose of ICMP. (Send error and control messages) 21. The command that saves the configuration stored in ram to nvram. (copy running-config startup-config) 22. 2 HDLC charcteristics. (Supports point-to-point and multipoint, Default serial encapsulation) 23. Three key features of CDP. (Does not require any layer 3 protocols to be configured, Verify connectivity, Will allow for the discovery of layer 3 addresses on neighbor routers) 24. What is the default IPX ethernet encapsulation. (Novell-Ether) 25. Which OSI layer is concerned with path determination. (Network) 26. Which OSI layer is responsible for data presentation, formatting and encryption. (Presentation) 27. Which command will show all DLCI configured. (show frame-relay pvc) 28. Which command will set the bandwidth on serial0 to 56k. (Router(config-if)#bandwidth 56) 29. Which command will change the name of the router. (Router (conifg)#hostname new name) 30. Split horizon never sends information back to the interface, from which it was received. 31. Valid LMI types (Q933A, ANSI, CISCO=default) 32. banner motd# is the command to set message of the day, and is displayed at he time of login. If you want to set a message to be displayed at the time someone accesses a specific interface you will use the command description at the interface level. 33. From global configuration mode which command will create sub-interface # 1 for serial 0. (int s0.1 point-to-point) 34. Which command enables load balancing over two multiple paths for IPX on a Cisco router. (ipx maximum-paths 2) 35. How do you determine which IP access-lists are applied to interface E0. (show ip interface e0) 36. What command will enable IGRP on a router. (Router IGRP autonomous # and to assign an address on the interface level write Network class(A,B,C), i.e. Router(config-if)#network 158.2.0.0 you don't specify the mask) 37. Computer A is transmitting data to computer B and expects an acknowledgment after every 4 packets. After a while the expected acknowledgment increases to 6 packets. This is an example of what. (Sliding window) 38. Trace is the command that determines the path a packet takes.<
|
|
| [ ] [返回上一页] [打 印] [收 藏] | |
上一篇文章：Cisco网络学院教程笔记(1)
下一篇文章：CCNA Study Notes2 |