精品推荐
阅读排行
· 工程竣工验收报告· 大学生毕业自我鉴定
· 大学生自我鉴定7
· 大学毕业生自我鉴定
· 大学生学年自我鉴定
· 大学毕业生自我鉴定
· 师范生实习鉴定评语
· 给老师的一封感谢信
· 心理健康教育论文
· 黑板报设计图欣赏
| 作者：不明 来源：www.pccode.net 整理 发布时间：2007-1-24 15:24:04 发布人：wongrs | |
|
> Configure AppleTalk on this interface? [no]: yes Extended AppleTalk network? [no]: yes AppleTalk starting cable range [0]: 1 AppleTalk ending cable range [1]: AppleTalk zone name [myzone]: One Configure IPX on this interface? [no]: yes IPX network number [1]: dadde Configuring interface Serial0: Is this interface in use? [yes]: Configure IP on this interface? [yes]: Configure IP unnumbered on this interface? [no]: IP address for this interface: 172.16.12.1 Number of bits in subnet field [8]: Class B network is 172.16.0.0, 8 subnet bits; mask is /24 Configure AppleTalk on this interface? [no]: yes Extended AppleTalk network? [yes]: AppleTalk starting cable range [2]: 12 AppleTalk ending cable range [12]: AppleTalk zone name [myzone]: WAN Configure IPX on this interface? [no]: yes IPX network number [2]: 3d Configuring interface Serial1: Is this interface in use? [yes]: no Additional configuration Now we will have to go back through each router and add the missing pieces. These are, IPX EIGRP, Appletalk EIGRP, IPX SAP filter, and the IP traffic filter. Lets do each one in turn. First the IPX EIGRP. This will require us to enable IPX EIGRP routing over the WAN the disable IPX RIP. First IPX EIGRP. We ll do this on R1. R1(config)#ipx router eigrp 100 You will need to use the same process ID on both routers. Now we ll enable IPX EIGRP over the WAN. R1(config-router)#network 3d Now disable IPX RIP over the WAN. We ll move from IPX EIGRP to IPX RIP with one command. R1(config-router)#ipx router rip R1(config-router)#no network 3d R1(config-router)#^Z Now repeat this on the other end (R2). Lets check our ipx routing table to verify our configuration. Show ipx route Codes: C - Connected primary network, c - Connected secondary network S - Static, F - Floating static, L - Local (internal), W - IPXWAN R - RIP, E - EIGRP, N - NLSP, X - External, A - Aggregate s - seconds, u - uses, U - Per-user static 3 Total IPX routes. Up to 1 parallel paths and 16 hops allowed. No default route known. C 3D (HDLC), Se0/0 C 4DDDD (NOVELL-ETHER), Et0/0 E DADDE [2195456/1] via 3D.0000.
|
|
| [ ] [返回上一页] [打 印] [收 藏] | |
上一篇文章：CCNA考试自测题第1卷（二）(1)
下一篇文章：CCNA专业英文词汇全集(3)(1) |