精品推荐
阅读排行
· 工程竣工验收报告· 大学生毕业自我鉴定
· 大学生自我鉴定7
· 大学毕业生自我鉴定
· 大学生学年自我鉴定
· 大学毕业生自我鉴定
· 师范生实习鉴定评语
· 给老师的一封感谢信
· 心理健康教育论文
· 黑板报设计图欣赏
| 作者：不明 来源：www.pccode.net 整理 发布时间：2007-1-24 15:24:04 发布人：wongrs | |
|
1990 by Meridian Technology Corp). X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. TN3270 Emulation software. 1 Ethernet/IEEE 802.3 interface(s) 16 Ethernet/IEEE 802.3 repeater port(s) 2 Serial network interface(s) 32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read ONLY) Notice: NVRAM invalid, possibly due to write erase. --- System Configuration Dialog --- At any point you may enter a question mark ? for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets [] . Would you like to enter the initial configuration dialog? [yes]: First, would you like to see the current interface summary? [yes]: Any interface listed with OK? value "NO" does not have a valid configuration Interface IP-Address OK? Method Status Protocol Ethernet0 unassigned NO unset up up Serial0 unassigned NO unset down down Serial1 unassigned NO unset down down Configuring global parameters: Enter host name [Router]: r1 The enable secret is a one-way cryptographic secret used instead of the enable password when it exists. Enter enable secret: cisco The enable password is used when there is no enable secret and when using older software and some boot images. Enter enable password: san-fran Enter virtual terminal password: san-fran Configure SNMP Network Management? [yes]: no Configure LAT? [no]: Configure AppleTalk? [no]: y Multizone networks? [no]: Configure DECnet? [no]: Configure IP? [yes]: Configure IGRP routing? [yes]: Your IGRP autonomous system number [1]:(The ASnumber mustbe the sameon all routers.) Configure CLNS? [no]: Configure IPX? [no]: yes Configure Vines? [no]: Configure XNS? [no]: Configure Apollo? [no]: Configure bridging? [no]: Configuring interface parameters: Configuring interface Ethernet0: Is this interface in use? [yes]: Configure IP on this interface? [yes]: IP address for this interface: 172.16.1.1 Number of bits in subnet field [0]: 8 (This is a Class B address with a mask of 255.255.0.0. We are adding 8 bits to that toget 255.255.255.0) Class B network is 172.16.0.0, 8 subnet bits; mask is /24
|
|
| [ ] [返回上一页] [打 印] [收 藏] | |
上一篇文章：CCNA考试自测题第1卷（二）(1)
下一篇文章：CCNA专业英文词汇全集(3)(1) |